![]() ![]() Configure ZeroTier NetworkĪt my./network/$NETWORK_ID Settings -> Advancedĭelete the default Managed Route. Hook up a keyboard and monitor and check with ip addr then edit `/etc/systemd/network/work` to match. Sometimes the physical interface turns out to be a long “predicatable interface name” like: “enb827eb0d4176”, sometimes it’s just “eth0”, depending on raspbian version(?). If it takes a long time waiting for the network during boot. You should be able to, from the physical LAN, connect to the Pi via $BR_ADDR You’d probably base this off what is already configured on your router. The DHCP range and ZeroTier Auto-Assign range should be in the same subnet, but not overlap. It doesn’t have a be a raspberrypi, but some of these instructions might be raspbian specific.īridge IP Address (will be statically assigned)Ĭreate a new ZeroTier network and get the ID Keep the old one around for secondary way to connect any devices already using ZeroTier. ![]() Anything running a Debian 10 based distro should be fine. We used a raspberry Pi 2 while writing this, but a Pi 3 or 4 should work fine. You could probably adapt the concepts to a different linux network configuration system if you have opinions about systemd. We’re going to use systemd networking for this. You’re somewhat familiar with the command line, ssh. Chances are high we’ll break networking and lose access to the Pi. You have a keyboard, monitor, and ethernet cable plugged into your Pi. You’re doing this on your home network and can log in to your router and find the DHCP settings. Do you have devices at home can’t run ZeroTier? Do you want access them remotely? Do you already use ZeroTier? You can use a small linux PC as a bridge between ZeroTier and physical networks. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |